Speaker & Headphone Test

Play a sound in each channel and tell us what you hear. We find swapped or dead channels, then test bass, the full frequency range and phase.

Runs 100% in your browserFree, no sign-upInstant diagnosis

How to test your speakers or headphones

  1. Start with a low volume.
  2. Play Left, then Right, and tap where you heard it.
  3. Use the bass test to find how low your speakers go.
  4. Run the sweep to find rattles and buzzing at specific frequencies.

What the results mean

You heard…Meaning
Left from the rightChannels swapped (cable or setting)
Nothing on one sideDead driver, broken cable or balance set fully to one side
Both sides for 'Left'Mono audio is turned on in your accessibility settings

Common speaker problems and fixes

  • No sound at all: check the output device in your system sound settings, the volume on the speakers and that they're powered on.
  • Only one side plays: check balance, the cable and the plug; swap the left and right cables to see whether the fault moves.
  • Crackling or buzzing: a loose cable, ground loop (hum from PC speakers on the same power strip), or a torn speaker cone at one frequency in the sweep.
  • Thin sound: speakers out of phase — run the phase test.

Where this test works

Device or browserWorksNotes
Windows, Mac, Linux, ChromeOSYesAny browser; use Chrome or Edge for 5.1/7.1 surround.
Phones & tabletsYesTurn off silent mode on iPhone to hear the tones.
Bluetooth audioYesBluetooth adds delay but doesn't change the results.

Frequently asked questions

How low should bass go?

Small laptop speakers start around 150–200 Hz, good headphones reach 20–30 Hz, and most desktop speakers stop around 50–80 Hz unless you have a subwoofer.

Is the sweep safe for my speakers?

Yes at moderate volume. Avoid high volume at the very low and very high end.

What frequency range should speakers cover?

Good desktop speakers reach about 50–60 Hz; with a subwoofer, 30 Hz or lower. Most people hear up to 15–17 kHz, less with age.

Do I need headphones for this test?

No — it's for speakers. For headphones use the headphone test, which explains channels and earcups.

More tests: Speakers & headphones