How to test a subwoofer
- Turn the volume down, then play the 60 Hz tone and raise it to a comfortable level.
- Click Bass limit. The tone slides down from 200 Hz — click the moment you can't hear or feel it anymore.
- Play each tone from 20 to 150 Hz. Listen for buzzing, rattling or a sudden drop at specific notes.
- Walk around the room: bass that's loud in one spot and gone in another is room placement, not a fault.
- On a 5.1 or 7.1 system, also play the LFE channel in the surround sound test.
What's a good result?
| Bass reaches | Meaning |
|---|---|
| 20–30 Hz | Deep, full-range subwoofer |
| 30–40 Hz | Typical home-theater sub |
| 40–60 Hz | Small sub or soundbar sub — check gain and placement |
| Above 60 Hz | The sub probably isn't playing; you're hearing the main speakers |
Subwoofer not working?
- Check the sub is on and not in standby; many wake up only on a strong signal — play 50 Hz loudly for a few seconds.
- Use the LFE / Sub In input with an RCA cable from the receiver's Sub Out.
- In the receiver (or Windows/Mac speaker setup), set Subwoofer: Yes and speakers to Small with an 80 Hz crossover so bass is sent to the sub.
- Turn the sub's gain knob to around halfway and its crossover knob to maximum (or LFE mode) when the receiver handles the crossover.
- Wireless soundbar subs: re-pair them with the soundbar's pairing button.
Rattles and buzzing
A buzz at one tone usually comes from something in the room vibrating — a shelf, window or picture frame. Hold or move it while the tone plays to find it. A distorted, crackling sound at every tone at moderate volume points to a damaged driver or a failing amplifier in the sub.
Where this test works
| Device or browser | Works | Notes |
|---|---|---|
| Windows, Mac, Linux, ChromeOS | Yes | Any browser; use Chrome or Edge for 5.1/7.1 surround. |
| Phones & tablets | Yes | Turn off silent mode on iPhone to hear the tones. |
| Bluetooth audio | Yes | Bluetooth adds delay but doesn't change the results. |
Frequently asked questions
Can laptop or phone speakers play these tones?
Barely. Built-in speakers usually stop around 150–250 Hz, so the lowest tones will be silent. That's normal — use headphones or a subwoofer for this test.
Is it safe for my speakers?
Yes at sensible volumes. Start low and turn up slowly; very loud tones below 30 Hz can make small speakers bottom out.
Why do I feel the bass more than hear it?
Below about 30 Hz, bass is felt more than heard. If you feel the floor vibrate, the sub is working even if the tone seems quiet.
What crossover should I use?
80 Hz is the THX recommendation and a safe default. Use 100–120 Hz with small satellite speakers, 60 Hz with large floor-standing speakers.
More tests: Speakers & headphones
- Speaker Test – Left/right, bass, sweep
- Headphone Test – Left/right, bass, range
- Left Right Audio Test – Is your stereo correct?
- Surround Sound Test – Every channel, one by one
- AirPods Test – Left & right AirPod check
- Laptop Speaker Test – Left/right & crackling